Shun Combination Whetstone 1000/6000
A dull unchipped steel edge can use the 1000/6000 progression with a hand-held angle. Maker source.
As an Amazon Associate I earn from qualifying purchases. Some links on this page are affiliate links — if you buy through them, we may earn a commission at no extra cost to you. Disclosure
You don't need a gadget to check an edge. Sharpener makers describe three simple tests in their manuals and FAQs. Each one answers a different question: is it sharp, is it finished, and am I at the right angle?
See relevant tools and maker limits
A clean paper cut is not a reason to buy. Hone with a suitable existing tool first when appropriate.
A dull unchipped steel edge can use the 1000/6000 progression with a hand-held angle. Maker source.
325/1200 diamond covers dull or uneven steel edges, but a crack or broken tip calls for service. Maker source.
| Check | Answers | When | Source |
|---|---|---|---|
| Paper test | Is the edge sharp? | Before deciding to sharpen, and after | Chef'sChoice 4643 manual |
| Burr check | Has this stage done its job? | During sharpening, before moving to a finer stage | Chef'sChoice 15XV manual |
| Marker method | Am I sharpening the whole bevel at this angle? | First session on a new angle or tool | HORL FAQ |
Hold a sheet of paper by one corner and slice down through it from the heel of the blade to the tip. The Chef'sChoice 4643 manual says a sharp knife "should cut paper smoothly," with only a slight roughness to the cutting action. The 15XV manual uses a sheet of paper the same way at the end of sharpening, as the sign to stop. If the blade snags, tears or skids, part of the edge is dull or rolled. Note where it catches: one spot usually means a local problem, the whole length means the edge is worn.
What to do next depends on whether honing helps. Hone and test again. If the paper still tears, it's time to sharpen. That's the logic in the hone-or-sharpen tool, explained in honing vs sharpening.
When you sharpen one side of an edge, the metal you push toward the apex folds over to the other side as a tiny lip: the burr. The 15XV manual uses it as the signal to move to the next stage. To feel for it, move your forefinger carefully across the edge, from the spine toward the edge. The manual is explicit: Never slide a fingertip along the cutting edge; that can cause a cut. A burr is a rough lip bent over from the edge, while the other side feels smoother.
No burr along the full length means the stage isn't finished. A burr along the full length means it is. A finer stage, or stropping, then removes it. HORL's ceramic disc is there for that: it "removes any burr and refines the grinding result."
HORL's sharpening guidance uses a marker test. Color the edge with a felt-tip pen on both sides, then sharpen as usual. Once the ink is gone from both bevels, the abrasive has reached the angle you chose. Ink left only at the very edge means you are working lower than the existing bevel; ink left at the shoulder means higher. It's the easiest way to see what a whetstone or a new sharpener is actually doing. Pair it with your knife's factory figure from the angle finder.
None of these tests measure the angle in degrees or the edge's durability. A knife can pass the paper test at 10° or at 20° per side. The narrower edge cuts more easily and is more delicate; the wider one is more robust. That's a question of the knife maker's design, not of sharpness. Check the factory figure on sharpening angles by brand before deciding to change it.
How fine the finish gets depends on the last grit. The grit chart shows what each step does, and how often to sharpen covers how long it should last.
Specs verified: November 2026 · Updated 2026-11-18 · How we choose